Hey there!
I am trying to send dmx values via Art-Net protocol to visualise fixtures in WYSIWYG. First, I configured and entered ip adress Art-Net for Wysiwyg. Then at first try i was able to send values and see the simulation properly... But after a while wysiwyg started to ignore received values from QLC.. I can monitor all the values are following nicely between to softwares.. But wysiwyg still does not effect any fixture... When i try same setup with gradMA on Pc everything works fine.. I really coudn't understand the what the problem is,, trying to figure out this issue since yesterday.. And it is really strange that, when my first attempt everything was running smoothly...
Does anyone have similar problems with Art-Net communication?
Communication with WYSIWYG
-
mcallegari
- Posts: 4825
- Joined: Sun Apr 12, 2015 9:09 am
- Location: Italy
- Real Name: Massimo Callegari
- Contact:
Hi, I think you should post this in the WYSIWIG forum (if they have one), not here.
As you said, QLC+ is working fine so I doubt there is anything we can do to make another software work
As you said, QLC+ is working fine so I doubt there is anything we can do to make another software work
-
janosvitok
- Posts: 1331
- Joined: Mon Apr 13, 2015 7:05 am
- Location: Bratislava, Slovakia
- Real Name: Jano Svitok
- Contact:
Try to move fader 512 in simple desk