Is there a way of adding an offset in the fixture definition so that the DIP diagram will show one less than the start channel number assigned?
My P2Fun scanners are set with channel 1 as 00000000, ch2 as 00000001 etc..
Could this be added possibly in the future?
Thanks.
DIP switch diagram where 00000000 is channel 1
-
Massimo Callegari
Wrong forum, moved.
I'm afraid this case won't be covered by QLC+ as it might be confusing for the rest 99% of users with fixtures where DMX address 1 is DIP 00000001
I'm afraid this case won't be covered by QLC+ as it might be confusing for the rest 99% of users with fixtures where DMX address 1 is DIP 00000001
-
Brenton Rowland
Thank for the reply Massimo, there are many cheap DMX fixtures that have the "first" channel as 0, I am sure others would benefit. Direct me to the module it is in and I will have a go at a mod that adds a check box alongside the DIP diagram labled "Start at 0" and subtracts 1 from the channel number before passing to the DIP diagram module.