Control speed of Scanner pan?

Musicutter · Thu Mar 06, 2014 8:38 pm

I have just added two Chauvet Intimidator 200 scanners to my set up. Is there a way to control the speed of the pan and tilt on the fixture? Thanks for any help.

Connor Faulder · Thu Mar 06, 2014 9:11 pm

I've just had a look at the manual for that scanner and without the movements being jerky, I'd presume that there's no way to alter the movement speed.

Musicutter · Thu Mar 06, 2014 9:32 pm

I am able to control the speed and create or use custom patterns with the scanners in Freestyler, I just like the interface and friendliness of QLC better and would like to be able to do the same here if it is possible.

Musicutter · Sat Mar 15, 2014 1:58 pm

Dummy me, I figured out I needed to do this in the EFX set up to create pan patterns, although I do not see a speed control for the pattern?

Joe · Mon Mar 17, 2014 5:06 pm

Add a speed dial to the workspace and add the efx to it. Unfortunately the speed dial uses seconds to calculate the movement speed, Rather than a logarithmic 0 - 10 rate like you might be used to.